REXON MC1850R, Instruction Manual

Page: 9 / 16

6
HEX WRENCH STORAGE (FIG. 6)
1. Place the hex wrench (1) into the hole (2)
on the left side of the tool for storage
when not in use.
ADJUSTING THE CUTTING DEPTH
(FIG. 7)
1. Turn the depth control lever (1) up to
loosen; turn the depth control lever (1)
down to lock.
2. Loosen the depth control lever to adjust
to the required cutting depth and then
tighten the lever.
ADJUSTING THE BEVEL ANGLE (FIG. 8)
1. Loosen the wing nuts (1) on the base at
the front and rear side.
2. Adjust to the desired bevel angle by
checking on the bevel scale (2). Then,
tighten the wing nuts (1).
Check that the power supply and outlet
used is in accordance with your marble
cutter. Have a look at the rating plate of the
motor, if any changes should always be
carried out by a qualified electrician.
Setting the Tool
7. Replace the outer flange (6), washer (5)
and arbor bolt (4).
8. Press the arbor lock (3-Fig. 3) while
tightening the arbor bolt (4) with a 6 mm
hex wrench.
9. Replace the dust cover back.
NOTE: Be sure to tighten all the parts
securely.
Removeing the blade
1. Loosen the lock bolt (1) with a 6 mm
hex wrench to remove the dust cover.
(Fig. 2)
2. Turn the depth control lever (2) up to
loosen and lift up the tool to the upper
most position. Then, turn the depth
control lever (2) down to lock in position.
3. Press the arbor lock (3) which is below
the motor. (Fig. 3)
4. Continue to hold the arbor lock (3-Fig. 3)
firmly while loosening the arbor bolt (4)
with a 6 mm hex wrench. (Fig. 4)
5. Remove the arbor bolt (4), washer (5),
outer flange (6) and blade (7).
NOTE:
●
Do not remove the inner flange.
● Remove the blade through the
slot (8) on the base downward.
6. If cracks or damage on the blade have
been found, replace a new blade by
following the steps of Installing the
blade .
INSTALLING RIP FENCE (FIG. 5)
1. Loosen the butterfly bolt (1) and inser
the rip fence (2) through the holes (3)
on the base.
2. Adjust the rip fence to the required
cutting width and tighten the butterfly
bolt.
WARNING! Make sure the collars are
clean and properly arranged.
WARNING! Replace the blade if cracks
or damge on the blade have been found.
WARNING! To avoid injury from an
accidental start, ALWAYS make sure
the switch is in the “OFF” position,
and the plug is not connected to the
power source outlet before making any
adjustments.
Connecting to the Power Supply
WARNING! Avoid contact with the
terminals on the plug when installing
(removing) the plug to (from) the power
supply outlet. Contact will cause a
severe electrical shock.