REXON MC1850R, Instruction Manual

Page: 5 / 16

2
conditions that may affect its operation.
A guard or other part that is damaged
should be properly repaired or replaced
by an authorised service centre unless
otherwise indicated in this instruction
manual. Do not use the tool if the switch
does not turn it on and off.
21. WARNING. The use of any accessory or
attachment other than one recommended
in this instruction manual may present a
risk of personal injury.
22. HAVE YOUR TOOL REPAIRED BY
A QUALIFIED PERSON. This electric
tool complies with the relevant safety
rules. Repairs should only be carried
out by a qualified person using original
spare parts, otherwise this may result in
considerable danger to the user.
23. THROUGH POOR CONDITIONS OF
THE ELECTRICAL MAINS, shortly
voltage drops can appear when starting
the EQUIPMENT. This can influence
other equipment (e.g. blinking of a
lamp). If the MAINS-IMPEDANCE
Zmax < 0.34 OHM, such disturbances
are not expected.
24. DO NOT USE SAW BLADES
MANUFACTURED FROM HIGH
SPEED STEEL.
25. KEEP THE FLOOR AREA AROUND THE
MACHIN LEVEL,
well maintained and free
of loose material e.g. chips and cutoffs.
26. USE CORRECTLY SHARPENED SAW
BLADES.
Observe the maximum speed
marked on the saw blade. Ensure that
the machine is always fixed to a bench,
whenever possible.
Additional Safety Rules For
Metal Cutter
1. Do not use grinding wheels.
2. Before operation, check the blade
carefully for cracks or damage.
Replace the cracked or damaged
blade immediately to avoid the possible
hazard.
3. Use correct size of saw blades. Always
use the blades that are recommended by
the manufacturer.
3. Never operate the product without the
blade guard.
4. Hold the tool firmly during operating. Do
not reach underneath the work. The
guard can not protect you from the
blade below the work. Do not attempt
to remove cut material when blade is
moving.
5. Never turn on the product when the
blade touches the workpiece.
6. Do not lay the metal cutter down until the
blade stops completely.
7. To prevent injury, be sure to unplug
from the power source outlet before
assembling, adjusting, or maintaining
the tool.
8. Keep your hands away from the cutting
area and the blade. Always hold the tool
with one hand holding on the switch
handle and the other hand holding on
the auxiliary handle.
9. Adjust the cutting depth to the thickness
of the workpiece. Less than a full tooth
of the blade teeth should be visible
below the workpiece.
10. Always use blades with correct size and
shape (diamond vs. round) arbor holes.
Blades that do not match the mounting
hardware of the tool will run eccentrically,
causing loss of control.
11. Do not use damaged or incorrect washers
or bolts or it will cause the loss of control.
12. To avoid injury, if the power cable is
damaged, do not change by yourself.
Please contact a qualified engineering
or local manufacturer to deal with.
13. When ripping always use a rip fence or
straight edge guide. This improves the
accuracy of cut and reduces the chance
for blade binding.
WARNING! For your own safety, read all
these instructions before attempting to
operate your product.