8
Use clean cloth to remove dirt, dust,
oil, grease, etc. Do not use gasoline,
turpentine, lacquer or paint thinner,
dry cleaning fluids or similar products.
Chemicals can damage, weaken or destroy
plastic which may result in personal injury.
Try not to let any liquid get inside the tool;
never immerse any part of the tool into
a liquid.
REPLACING CARBON BRUSHES
(FIG. 13)
NOTE:
Replace both carbon brushes
when either has less than 6 mm length of
carbon remaining, or if the spring or wire is
damaged or burned.
1. To inspect or replace brushes, first
unplug the machine.
2. Remove the carbon brush cap (1) on
the side of the motor (2). Pull out the
carbon brush and replace it.
3. Repeat the above steps for the carbon
brush located on the other side of motor.
Maintenance
WARNING! To avoid injury from an
accidental start, make sure the switch is
in the OFF position and the plug is not
connected to the power source outlet.
Summary of Contents for MC1850R
