REXON MC1850R, Instruction Manual

Page: 10 / 16

7
TRIGGER SWITCH (FIG. 9)
1. To turn on the machine, press the lock-off
button (1) and hold it firmly while
pressing the trigger switch (2).
2. To turn the machine off, release the
trigger switch (2).
USING THE RIP FENCE (FIG. 5)
When doing a straight cut, the rip fence
would be a better accessory to apply with.
1. Loosen the butterfly bolt (1).
2. Slide the rip fence (2) to the desired
cutting width and tighten the butterfly
bolt.
NOTE: Make sure the bolt is tight
enough to avoid influencing the cutting
accuracy.
Operating the Tool
USING AN EXTENSION LEAD
The use of any extension lead will cause
some loss of power. To keep this to a
minimum and to prevent overheating and
motor burn-out, ask advice from a qualified
electrician to determine the minimum wire
size of the extension lead. If the power
cable is broken, repair service is available
at your nearest service center.
WARNING! Never connect the plug to the
power source outlet until all installations
and adjustments are completed and you
have read and understood the safety and
operation instructions.
USING THE AUXILIARY HANDLE
(FIG. 10)
The auxiliary handle (1) is pre-assembled
at the factory. It alows the user holding
firmly while doing the cutting operation with
the tool.
STRAIGHT CUT (FIG. 11)
1. Mark a cutting line (1) on the
workpiece (2).
2. Adjust the rip fence (3) to match with
the cutting width if needed.
3. Hold the machine firmly and align the
blade with the cutting line.
4. Turn the mahcine on and wait to its full
speed and move the machine forword in
alignment with the cutting line.
NOTE: Do not allow the blade touch the
workpiece before it comes to full speed.
BEVEL CUT (FIG. 12)
1. Mark a cutting line (1) on the
workpiece (2).
2. Adjust the rip fence to match with the
cutting width if needed.
3. Loosen the wing nuts (3) on the base at
the front and rear side.
4. Adjust to the desired bevel angle by
checking on the bevel scale (4). Then,
tighten the wing nuts (3).
5. Hold the machine firmly and align the
blade with the cutting line.
6. Turn the mahcine on and wait to its full
speed and move the machine forword in
alignment with the cutting line.
NOTE: Do not allow the blade touch the
workpiece before it comes to full speed.
WARNING! Forcing and applying
excessive pressure might allow the
blade to bend. Pinch or twist in the cut
can cause overheating of the motor and
dangerous kickback of the tool.