5
INSTALLING AND REMOVING THE
BLADE (FIG. 2, 3, 4)
Installing the blade
1. Loosen the lock bolt (1) with a 6 mm
hex wrench to remove the dust cover.
(Fig. 2)
2. Turn the depth control lever (2) up to
loosen and lift up the tool to the upper
most position. Then, turn the depth
control lever (2) down to lock in position.
3. Press the arbor lock (3) which is below
the motor. (Fig. 3)
4. Continue to hold the arbor lock (3-Fig. 3)
firmly while loosening the arbor bolt (4)
with a 6 mm hex wrench. (Fig. 4)
5. Remove the arbor bolt (4), washer (5)
and outer flange (6).
NOTE:
Do not remove the inner flange.
6. Rotate the lower blade guard and hold
it firmly for preventing rebound while
installing the blade (7) onto the shaft.
NOTE:
Place the blade through the
slot (8) on the base upward.
WARNING! For your own safety, never
connect the plug to power source outlet
until all assembly steps are completed
and you have read and understood the
safety and operational instructions.
Assembly
KNOW YOUR METAL CUTTER (FIG. 1)
1. Side cover
2. Rip fence
3. Lower blade guard
4. Base
5. Trigger switch
6. Switch handle
7. Auxiliary handle
8. Lock-off button
9. Bevel adjusting nut
10. Bevel scale
11. Depth control lever
12. Carbon brush cap
13. Motor
Motor ............................................. 1400 W,
220 V~, 50/60 Hz
Blade Size .................................. Ø185 mm;
Ø20/Ø25.4 mm Bore
No Load Speed .......................... 3500 min
-1
Max. Depth of 90° Cut ..................... 59 mm
Max. Depth of 45° Cut ..................... 41 mm
Installation
Specifications
WARNING! Noise can be a health hazard.
When the noise level exceeds 80 dB (A),
be sure to wear ear protection.
WARNING!
●
Be sure to use Ø 185 mm blade. Other
sizes of blades are not recommended.
●
To avoid injury from an accidental
start, make sure the switch is in the
OFF position and the plug is not
connected to the power source outlet.
WARNING! To avoid damaging the
machine, be sure to fit the blade with the
inner collar. If not, serious injury might
happen.
Summary of Contents for MC1850R
