14
OPERATING INSTRUCTIONS FOR ACCESSORIES
LED pool lights (REXENER Aurora/Polar)
•
REXENER Aurora and Polar hot tubs are equipped with pool lights. The RGB pool light is adjusted
with a remote control.
•
The hot tub has no separate button to control the lights. The lights are turned on and off by pressing
the remote-control button.
•
You can leave on only one light or use several pre-programmed colour programmes by operating
the remote control.
•
The remote control must not be touched with wet hands, because it is not water resistant.
•
The remote control should be stored in a warm place indoors.
•
The electric cord of the LED light is connected to the socket in the protective case
Whirlpool bath kit (REXENER Polar)
•
REXENER Polar is equipped with a whirlpool bath kit.
•
The switch, pump, nozzles and electric cord of the whirlpool bath kit have been pre-installed. The
pump and electric cord of the whirlpool bath kit are located inside the frame, close to the edge on
the box’s side. From there, it is easy to connect them to the pre-installed socket in the box.
•
The button of the whirlpool bath kit is installed at the pool’s edge, on the side of the step
•
The whirlpool bath kit is turned on and off by pressing the button located on the pool’s edge.
•
The electric cord of the whirlpool bath kit is connected to the socket in the protective case
Please note!
REXENER Polar hot tubs are equipped with whirlpool bath kits. Water can remain in the pipes of whirlpool
bath devices, even though the pool is emptied. The water does not drain from the piping on its own. The
whirlpool bath device must be turned on when draining the pool after the water surface is below the
whirlpool nozzle. This way, whirlpool bath pipes are completely emptied of water, and the problems and
damage caused by the eventual freezing of pipes can be avoided.
