13
REXENER AURORA/
POLAR, INSTALLATION
INSTRUCTIONS
Connecting the protective case and hot tub
1.
Install the hot tub in its designated place.
2.
Install the protective case on the un-
boarded side of the hot tub.
3.
The lower suction hose is connected to the
connection at the end of the circulation
pump.
4.
The upper return hose is connected to the
uppermost connection on the side of the
REXENER PR200 water heater.
5.
After connecting the hoses, the protective
case cover is installed.
6.
Install the water heater’s smoke pipe.
Attach the pipe to the heater with three
screws.
7.
Install the plate intended around the smoke
pipe feed through, and attach it with four
screws.
8.
The protective case includes a pre-installed
electric cord. The plug is pulled out through
the hole.
9.
All electric cables, lights, the whirlpool bath
kit (only REXENER Polar) and the REXENER
PR200 water heater are connected to the
socket pre-installed in the protective case.
10. Install the decorative strips delivered with
the box.
The upper hose is connected to the uppermost
connection PR-200
The lower hose is
connected to the
Rexener water
circulation pump’s
connection
Pump
Tank
Power socket
