R E V V
| G E N E R AT O R 1 2 0 M K 3
22
FOOT
CONTROLLER
The Revv footswitch can be configured to either
operate as a normal footswitch (with some bonuses) or
a tool to quickly recall presets on the amplifier.
Control Mode:
Select between all four channels, drive,
aggression modes, fx loop on/off, master volumes, and
a master mute function.
Preset Mode:
Select combinations of channel and
fun master volume select & FX Loop on/off that
can be recalled with one button press.
Note:
To switch between modes, press & hold the
footswitch button 1 for 2 seconds. The LEDs will all
illuminate then switch to the settings in the other mode. All
settings will be retained when switching between modes.
HOOK UP
53
The footswitch is connected to the rear of the amplifier
with a 5 PIN DIN Cable. The amplifier & footswitch
will work with any 5 PIN DIN cable should you be in a
pinch, but the Revv cable is always recommended for
best performance.
It is recommended that the footswitch be connected
to the amp with the power off, but should you plug it
in during amplifier use, it will power up & automatically
set itself to the amps current settings. Upon power-
up, all LEDs will turn on for a couple of seconds as it
initializes. Once complete, the foot pedal will set itself
to the amplifier’s current configuration.
CONTROL MODE
54
The foot pedal will always power up in control mode.
This mode works similarly to most other foot pedals - it
simply controls the functions of the amp. Here is how
the buttons respond in control mode:
BUTTON 1
This button has 3 functions, it switches to channel
one when the amp is not in channel one, switches
between clean and clean wide & switches between
foot pedal modes when held for 2 seconds (control
& preset).
BUTTON 2
This button will switch to channel two when the amp is
not in channel two. It will also toggle through Channel
2 drive modes when in the amp is in channel 2.
BUTTON 3
This button has two functions, it will switch to channel
3 when the amp is not in channel three, & cycle
through aggression levels when in channel 3.
BUTTON 4
This button has 2 functions, it will switch to channel 4
when the amp is not in channel four, & cycle through
aggression levels when in channel 4.
BUTTON 5
This button toggles FX Loop In/Out.
BUTTON 6
This button has 2 functions. Pressing it toggles
between the 2 master volume controls, whereas
holding it for 2 seconds activates the mute ability &
the LED will flash.
