M10
Re:system
20
CLIENT LIST
The CLIENT LIST shows all devices
that are currently accessing the M10.
Up to 10 clients can have parallel
access.
If no client is logged on, four zeros
appear in the corresponding line.
In the example below, three clients
are accessing the M10. The IP
address of each client is shown.
Using the menu softkey, you can
toggle between the CLIENT LIST
menu page and the two TCP/IP
pages.
The Access Point required for the radio
transmission does not appear with its
IP address in the CLIENT LIST.
Page
TCP/IP
The base settings for the Ethernet
access are set through the two
TCP/IP pages.
The setting is made by selecting the
corresponding address block with
the softkeys, which is then shown in
square brackets 192.[168].0.6
Now the required setting can be
made using the two display keys Jog
[+ / -].
The new settings are confirmed with
the Apply softkey. Otherwise the
previous setting is retained.
Note
All settings in the M10 setup are
made using the Jog [+/-] keys. The
following symbol additionally draws
your attention to it in the manual: [ ]
