4
EN
4
EN
This device also must be located in a place and in a manner to be easily accessible at any
moment by the operator.
OVENS WITH CABLE AND SINGLE PHASE PLUGS
For appliance with cable and plug (single phase 220-240V) the plug merely needs to go into
the appropriate socket (the socket must be adapted for the supplied plug and must withstand
the voltage required by the appliance indicated on the information plate). The product must
be positioned so that the plug is always accessible.
The appliance comes with certified cable and plug therefore they must not be tampered with
or modified. Only the cable can be substituted:
this must be carried out by a qualified
authorized technician.
The earth wire must always be yellow green.
APPLIANCE NOT SUPPLIED WITH CABLE WITH
THREE PHASE TERMINALS
Articles supplied by us come with terminals such as in the image. To connect to the mains see
the label in the manual and stuck to the lower part of the back of the appliance near the
Information Plate .
The oven must be connected to the electricity with a rubber cable such as H07RN-F.
WARNING: the yellow/green voltage wires in the earth cable must be 3cm longer than
the others.
The oven must be connected directly to the mains and must have an easily accessible switch
from the start ,installed for the device according to the national, international and local laws in
the country where it is installed. This switch must separate polarization guaranteeing complete
disconnection in accordance with the overvoltage III category.
Correct earthing is obligatory and the earth wire must not be operated by the protection switch.
CABLE CONNECTION
Proceed as follows to connect the power supply wire to the terminal board:
( A1 ) Loosen the tops of the cable gland and open the bottom part of the back of the
appliance by loosening the screws.
( A2 ) Feed the new cable through the cable gland. Connect the cable voltage to the
terminal strips following the connection diagram on the label on the back of the
appliance. Only connect what is indicated inserting the copper bridge and the electricity
cable together under the screws, in the tightening direction, so the cable and the bridge
are tightly fixed by tightening the screw. The type of cable to be used (HO7RN-F) is
indicated on the label for each connection and the voltage sections in mm².
( A4 ) Close the bottom part of the back of the appliance by tightening the screws and fit
the cable by tightening the cable gland top.
