3
EN
3
EN
The oven must be placed on a flat surface so that it does not slip or turn over.
The installation area must be able to support the weight of the appliance filled to the
maximum.
See the information level on the back of the oven for the gross weight.
Make sure that it is placed so that the door may be fully opened.
Position it so that the back of the oven is easily accessible for maintenance, connection to the
mains sockets, and water.
The appliance is not meant to be fitted and a 5 cm space must be left all round it.
Do not position other heat sources like, fryers or hotplates, near the oven. If this is not
possible at least respect the following distances from machinery: 50 cm from the sides and
above the appliance and 70 cm from behind.
Do not place the device near materials or containers of inflammable liquids (such as walls,
furniture, screens, gas canisters) as it can be a fire hazard. If this is not possible, cover the
inflammable parts with fire and heatproof material and by checking fire hazard regulations.
IV. PREPARING FOR INSTALLATION
Remove the outer packaging (wooden or carton box) and dispose it in compliance with the
laws in force in the country of installation.
REMOVING PROTECTIVE FILM ETC.
Remove the protection film from the
external and internal walls. (See
image)
Remove all information covering
from the inside, and take off all
plastic packaging.
STAND ADJUSTMENT
Do not use the appliance without feet.
The adjustable feet are already screwed to the underside of the oven.
If they are not used, this prevents airflow from cooling the electric parts and outsides of the
oven which causes over-heating and damage to components.
The oven will function correctly if placed level on a flat surface by adjusting the feets
accordingly and using a spirit level. Screw or unscrew them as necessary to adjust.
V. ELECTRICAL
CONNECTION
WARNING: Mains connection must be carried out by a qualified and authorized
technician according to national, international and local laws in the country where it is
installed. Before mains connection, ensure that the frequency (
..V) and voltage
(
.Hz) meet the requirements indicated in the in the information tag on the back of the
appliance.
The electric system, as prescribed and specified by the Standard in force, must be equipped
with an efficient ground. It is possible to guarantee the electric safety of the appliance only in
the presence of Standard electric system.
For direct connection to the mains, it is necessary to interpose a device between the
equipment and the same mains, sized for the load, that ensure its disconnection. The
contacts must have an opening distance enabling the full disconnection, in conditions of over-
voltage category III, per compliance with installation regulations.
