Revell Control 24036, Manual

Page: 6 / 60

6
Note:
Before recharging and after every flight, always wait 10 to 15 minutes for the battery to cool down in order to avoid damage. Never leave the helicopter unattended when recharging.
Charging the Helicopter
Pic. 1 Pic. 2
1. Turn off the helicopter and the controller.
2. Pull out the charging wire from the bottom
of the controller (pic. 1).
3. Carefully plug the charging wire into the
helicopter’s charging port (pic. 2). The charging
wire should fit easily into the charging port –
DO NOT FORCE. Inserting the charging wire
incorrectly may damage the helicopter and
cause injury.
4. Turn the power switch on the controller to
“ON” (Charge) (pic. 3).
5. The red Power ON LED flashes and the green
charging status LED lights up now (Fig. 4).
6. The charging procedure is complete as soon as
the green charging status LED has gone out.
7.
After charging, turn the power switch to
“OFF” and remove the charging wire from
the helicopter.
The helicopter can be flown for about 8 minutes
after approximately 30 minutes of charging
Helicopter and Controller
Helicopter
Controller
Insert Batteries
1. Remove the screw
to release the bat-
tery cover and slide
downwards.
3. Slide the battery
cover upwards
and screw in
place.
Pic. 4
Pic. 3
2. Insert six 1.5 V AA batter-
ies following the polarity
shown inside the battery
cover.
Direction stick
(forwards, backwards,
left and right)
Band selector (A, B, C)
“POWER ON” LED
Starting position
Note: Before
turning on the con-
troller, the throttle
stick must be in the
down position.
Battery cover
ON/OFF switch
Charging port
Infrared signal emitter
Power ON/OFF and
charge switch
Right and left trim dial
Charge status LED
Throttle stick
English
Counter-rotating
rotor blades
Stabilizer
Tail rotor
Landinggear
LED lights