Installing additional equipment
75
9.3 DR 100 feed unit
With the DR 100 feed unit, larger quantities of sample material can be fed evenly through the
noise protection funnel during the grinding process.
An additional interface cable is required to connect the unit to the DR 100 feed unit. The voltage
and frequency must be checked against the nameplates of the device and the DR 100 feed unit.
The best choice is a multiple socket to which the device and the DR 100 feed unit are
connected, but no other devices.
9.3.1 Installing the DR 100 feed unit
For installation and operation, also observe the assembly instructions for additional
equipment.
Install the DR 100 feed unit as follows:
Fig. 51:
Stand opening position
1. Switch off the device.
2. Remove the plastic plug from the stand
opening (5) (e.g. with a slotted screwdriver)
(
3. Remove the transport lock at the bottom of
the DR 100 feed unit (33).
5
