First Commissioning
31
Fig. 11:
Moving the scale
Move the scale (
J
) if the pointer (
K
) on the scale (
J
) is
not
on “0”:
Unscrew the two hex screws (
KS
).
Move the scale (
J
) sideways until the pointer is on zero.
Tighten the two hex screws (
KS
) again.
Then set the desired gap width for the next grinding process.
NOTICE
Always set the gap width of the ABP 250 to
more than 0 mm
. Where the minimum
gap width is required, open the gap just wide enough for the meeting of the two jaws to no
longer be audible.
Any blockage that arises can cause damage to the mechanical components.
5.6.2 Setting the gap width
Fig. 12:
Adjusting the gap width
Start the ABP 250 while the device is idling.
Unscrew the lock nuts (
F
) in a clockwise direction.
Unscrew the locating screw (
P
) in an anticlockwise direction.
Reduce the gap: turn the threaded spindle (
G
) to the right.
Increase the gap: turn the threaded spindle (
G
) to the left.
F
G
K
J
P
KS
J
Summary of Contents for ABP 250
