DETAIL B
Page 6 of 10
(AA)
1
4
" x 1 -
3
4
" BOLT = 04 PCS
AA
ALLEN WRENCH = 01
STEP #1
HEAD BOARD & End Rail Panel ASSEMBLY
HARDWARE FOR STEP #1:
STEP #1.1
Gently lay the Headboard and End Rail Panel on
their backs on a clean and non-abrasive surface.
STEP #1.2
Align and insert the threaded rod of the Legs into
the hole on the bottom of the Headboard and End
Rail Panel and turn clockwise to tighten. Please
see DETAIL A.
STEP# 1.3
Bring the headboard and End Rail Panel in upright
position.
NOTE:
On both end of the Headboard are holes for the
bolt to pass through that correspond to the holes
located on both ends of the End Rail Panel with
pre-installed nuts.
STEP#1.4
Align the hole of the End Rail Panel with the holes
of the Headboard then insert Allen Head Bolt into
hole and tighten with Allen Wrench provided.
Please see DETAIL B.
DETAIL A
