Page 10 of 10
DETAIL L
STEP #5.1:
Remove the Front Rail Panel of the crib by loosening all
the bolts installed.
STEP #5.2:
Gently tilt the Crib and release the bolts underneath the
metal brackets holding the Stabilizer Rails.
STEP #5.3
Gently remove the Mattress Support and slightly loosen
the bolt at the back of the Headboard that enough to set
the Toddler Rail in-between End Rail Panel.
NOTE: Fill the holes located on the top of the End Rail
Panel by inserting bolt (EE) provided.
STEP #5.4
On inside face of both End Rail Panels there is a cavity
for the hook which corresponds to the hook on both
ends of the Toddler Rail. Align and insert the hook of
the Toddler Rail into the cavity of the End Rail Panel as
in DETAIL K.
-NOTE:
If Mattress Support is not in the lowest position,
unscrew Mattress Support bolts and move the lowest
position.
STEP #5.4
Repeat step #3. Installation of Stabilizer Rails into the
End Rail Panel (DETAIL L)
After assembly, re-tighten all bolts to a snug fit.
Thank you for your purchase
www.rhbabyandchild.com
(EE)
1
4
" x
1
2
" bolt = 2 PCS.
ALLEN WRENCH
STEP #5
TODDLER RAIL ASSEMBLY
HARDWARE FOR STEP #5
DETAIL J
EE
EE
