Page 7 of 10
HARDWARE FOR STEP #2:
(BB) 1-
3
8
" X
1
4
" Ø MATTRESS BOLT = 8 PCS.
(BB) MATTRESS NUT = 8 PCS.
(BB)PLAIN WASHER = 8 PCS
(BB)LOCK WASHER = 8 PCS
MATTRESS
NUT
PLAIN
WASHER
MATTRESS
BOLT
ALLEN
WRENCH
MATTRESS
BOLT
MATTRESS
BOLT
MATTRESS
BOLT
MATTRESS
BOLT
ALLEN WRENCH
OPEN WRECH
MATTRESS NUT
LOCK WASHER
PLAIN WASHER
MATTRESS
SUPPORT
STABILIZER RAIL
STEP #2
MATTRESS SUPPORT ARM ASSEMBLY
STABILIZER RAIL ASSEMBLY
MATTRESS HEIGHT ADJUSTMENT
STEP #2.1
Lay Mattress Support flat with Stabilizer Rail on each
side
Note:
On each end of the arm of the Mattress Support, there is
a hole for the bolt to pass through that corresponds to
the holes located in the frame of the Mattress Support.
STEP #2.2:
Insert the Allen Bolt into the desired hole of the frame
through the hole on the arm support. Fasten the bolt with
Plain Washer, Lock Washers & Hexagonal Nut provided.
Repeat procedure on other arms of the Mattress
Support. Please see DETAIL C.
WARNING:
Set the Mattress Support to the desired height by
adjusting the support arms. The Mattress Support
should be at its highest setting for newborns, then
adjusted to the lower positions as the child grows and
becomes mobile. Once the child is able to stand, the
Mattress Support should be at its lowest position.
STEP #2.3:
Install the Stabilizer Rail at ends of the Arm Support as
illustrated on DETAIL D .
DETAIL C
DETAIL D
ALLEN WRENCH
B
C
LOCK
WASHER
