Tactical ResQmax Operation Manual
12
Figure 10b - Disconnecting Launcher
from Line Container
Figure 10a - Connecting Launcher
to Line Container
Step 1
Step 3
Step 2
Step 1
To connect the Launcher to the Line
Container, follow these steps:
1. Place the inverted “T” bracket (on the
bottom of the Launcher at the front) on
top of the Line Container just behind
the inverted “T” groove on the upper
portion of the front of the Line Container
(Fig. 10a - Step 1).
2. Position the bottom of the Handle so
that notches on the Handle will engage
with the flange at the rear of the Line
Container (Fig. 10a - Step 2).
3. Slide the Launcher forward inside both
the front and rear grooves of the Line
Container simultaneously. Push firmly
forward until the Line Container Catch
on the Launcher automatically engages
in the locking hole in the Line Container
(Fig. 10a - Step 3).
Step 2
Connecting the Launcher to the Line Container
Disconnecting the Launcher from the Line Container
To disconnect the Launcher from the Line
Container, follow these steps:
1. Push down on the Line Container Catch,
located at the front of the Launcher
just below the launcher barrel opening
(Fig. 10b - Step 1).
2. Slide the Launcher back and out of the
grooves on the Line Container (Fig. 10b
- Step 2).
Note:
If there is line
in the Line
Container it is
first necessary
to disconnect
the “live end”
from the Bridle
Lines and the
“dead end” from
the Launcher
Eyelet in order
to disconnect
the Line
Container from
the Launcher.
