Repotec RP-UPH, User Manual

Page: 8 / 17

14
4 CABLE CONNECTION
4.1 Inspection
1. The system may be installed and wired only by qualified electricians in
accordance with applicable safety regulations.
2. When installing the electrical wiring, please note the nominal amperage of
your incoming feeder.
3. Inspect the packaging carton and its contents for damage. Please inform
the transport agency immediately should you find signs of damage. Please
keep the packaging in a safe place for future use.
4. Please ensure that the incoming feeder is isolated and secured to prevent
it from being switched back on again.
4.2 Connection
1. UPS Input Connection
If the UPS is connected via the power cord, please use a proper socket
with protection against electric current and pay attention to the capacity of
the socket.
2. UPS Output Connection
The output of this model is with socket-types only (NEMA or IEC). Simply
plug the load power cord to the output sockets to complete connection.
15
5. Operation
5.1 Check Prior to Start Up
1. Ensure the UPS is in a suitable positioning.
2. Check input cord is secured.
3. Make sure the load is disconnected or in the “OFF” position.
4. Check if input voltage meets the UPS rating required.
5.2 Operation Procedure
Please follow the instructions below for the UPS operation.
1. Once the AC source is connected, the LCD Display shall light up
immediately to display first the
main menu of greeting context
and the Normal LED is blinking to
indicate ready to switch on the
inverter.
2. By pressing the UPS on/off Control Key and the LCD Select
Down-key simultaneously for 3 seconds until the buzzer beeps twice,
the UPS will start up and Normal LED lights up to indicate the power
is from its inverter to the load.
3. When the LCD Select Down-key and the LCD Select Up-key are
pressed simultaneously for 3 seconds until the buzzer beeps twice,