button is clicked. "Egypt" is still the valid configuration. A reboot would
completely remove the “Finland” value at this stage.
4. When “Set” was clicked, the configuration pane to the left
should also have been populated with an “Apply” button and
an option to select “Safe apply” with a time. See figure
below.
Figure 7 - Apply button and "safe apply" option visible after
the "Set" button is clicked.
5. For the new setting(s) to take effect, click the “Apply” button
(you can change several parameters before clicking
“Apply”). This might cause the browser to lose contact with
the web GUI for a short while. When it is back, the new
configuration area is active and stored in the RAM memory.
To make the changes permanent you have to click “Save” as
shown in the figure below.
Figure 8 - Select Save in order for the new configuration to be permanent.
6. If “Safe apply” was selected before “Apply” was pressed, the
unit will roll back to the current (working) configuration after
the stated time if you lose the node after reboot. The default
time is 5 minutes. It is strongly suggested to use the “Safe
apply” option for field mounted links as it will bring your link
back in operational and manageable state even if you make
configuration mistakes that makes you lose the node.
