Page 15(17)
Configurable from LAN:
This parameter is only visible when CPE is in bridge mode. It
controls if the mgmt IP is accessible from the LAN side. If
“No” is chosen the subnet and/or VLAN is not accessible
through the CPE.
Important information
In routing mode:
The subnet defined here will not be accessible from the LAN
side. IF DHCP is used for the WAN port and the same subnet
is defined for the mgmt IP the CPE will not be able to
communicate correctly with the WAN side.
In bridge mode:
If configurable from LAN is disabled the defined VLAN
and/or subnet will not be accessible from the LAN side.
Domain:
This parameter controls the regulatory domain in which the
modem is used. Different regulatory domains give access to
different channels.
RTS/CTS:
This parameter controls which data frames that should use
RTS/CTS before the actual frame is sent. If the frame is larger
than this value it will use RTS/CTS.
Frag size:
Frames larger than this value will be fragmented into smaller
frames where the biggest frame has this parameters size.
Distance:
Configures the distance to the base station. This value controls
the different timeouts used in the communication with the base
station. A to low value could result in packet loss.
TX Power:
These parameters control the output power of the radio. The
maximum allowed power differs between different regulatory
domains. The actual radiated power is also affected by the
antenna used.
Password:
You can change the admin password, type in the new
password in both fields and press apply. This password is used
when you login as “admin”.
Maintenance tab
On the Maintenance tab you can upgrade the CPE and adjust the RSSI indication mode.
Firmware and Documentation
Support page:
This is linked to the support page at Repeatit. You will come
to the correct page with the valid Firmware for your CPE
model. Chose download and choose “Save to disk”.
Firmware upgrade:
When you have downloaded the Firmware press this button
and browse for the downloaded file. Then press “Upgrade”
The CPE will now be upgraded with the new Firmware. The
status LED (middle LED) will flash slowly during the
