Installation Guide RN5000US
45
5.6 Closing the Digiwatts unit
When you have finished connecting the AC-output wires, the DC-input wires, re-check
all your connections to ensure that everything is in the right place and that all
connections and knockout fittings are secure and properly torqued.
Check all of the
knockout fittings on the bottom of the Digiwatts unit to ensure that they provide a
weather-tight seal.
WARNING!
Never install the Digiwatts unit during rain or very damp conditions.
Because
the Digiwatts unit is completely sealed, you must be sure no moisture is
trapped inside the enclosure when securing the lid.
CAUTION!
Be careful not to misplace the machine screws or the enclosure seal that
attach the cover to the case, as all four screws and enclosure seal are required
to ensure that the cover is grounded properly and is fully sealed to the case.
Handle the cover carefully, as even seemingly minor damage to the cover
could result in an inadequate seal between the cover and the case, thus
allowing moisture to enter the case and damage the sensitive electronic
components.
Use the following procedure to replace the cover on the Digiwatts unit:
1) Secure the three connections with the appropriate mating connectors on the
LCD board.
2) Check wire routing to ensure that no wires can interfere with proper sealing of
the cover and that no pressure will be exerted on the connections when the
cover is replaced.
3) Locate the four machine screws and enclosure gasket you removed to take the
cover off the Digiwatts unit.
Make sure you have all four screws and enclosure
