8
Installation
Recommended tools to have before installation (Not provided):
Socket wrench
Torque extension
Box-Leveler
Tape Measure
18mm wrench or socket for larger hex nut
13mm wrench or socket for smaller hex nut
The above tools and equipment are highly recommended to have available to assist with
installation but are in no way a comprehensive list of tools that can ease installation. Installers
feel free to substitute comparable equipment where appropriate.
Note:
All Cap Head Bolts (G) must have a Washer (H) and Spring Washer (I) prior feeding
through a hole.
Fasten L-Channels to L-Brackets
A. Place Washer (H) flush to top surface of L-Channel (B), and align the holes.
B. Slide the Spring Washers (I)) onto the Cap Head Bolt’s (G) thread so that the bottom face
of the Cap Head Bolt is touching the top surface of the spring washer.
C. Feed the thread of the Cap Head Bolt (G) through both L-Channel (C) and Washer’s hole.
Repeat for all 4 holes.
D. Align the L-Bracket (C) with the bottom face of the L-Channel (B) and feed the protruding
threads through the L-Bracket holes. Make sure the L-Bracket is flush and tighten bolts.
E. Fasten the L-Bracket (C) to L-Channel (B) with two small Nuts (K).
F. Repeat for both sets of L-Channel (B), fasteners, and L-Bracket (C).
Figure 1
B
G
I
H
K
C
