i
Point Source Array Modules
8
The complementary cabinet angles and tightly controlled dispersion that allow the sonic outputs of VARIAi array modules to be smoothly mixed to
obtain the desired coverage perform just as well in horizontal arrays as they do in vertical line arrays.
Joining two VA101i-22 22.5º modules together in a horizontal array or cluster produces a seamless 45º horizontal pattern; use three 22.5º modules
for 67.5º of horizontal coverage and 4 for 90º. Or use 6 VA101i-22 modules for 135º of horizontal coverage.
To assemble a horizontal array, stand the cabinets on end and connect them together using MPS connectors. The RHANG-VA101iH is used to
provide easy rigging points on top of a horizontal array in any position. These come in sets of 2 along with the M8 x 45mm HEX bolts needed for in
-
stallation and are added to the array in addition to the MPS connectors. The MPS connectors are installed as normal with the exception of the bolts.
Install the RHANG-VA101iH on the outside of the enclosures using the provided bolts that will hold it, and MPS connector, in place.
Note that the RHANG-VA101iH hardware accommodates only the 22.5 degree VA / VAX101i-22 You should not attempt to use it with the other
VARIAi modules.
For horizontal clusters,
If severe down angles are required, it is recommended to add the REAR PIC BARS as needed to provide this connection.
The
RHANG-VA101iH is used in pairs and
can be placed where needed in the array
Horizontal Arrays
