This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in
electronic data processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
This publication represents the technical status at the time of printing.
Copyright 2017 by Conrad Electronic SE.
*1528625_V2_0217_02_LS_m_GB
(13)
(20)
(19)
(18)
(19)
(18)
14
• Step 14: Place the enclosure from step 13 onto the 3D printer. The back cover (10) should
be on the back of the printer.
Tighten the countersunk screw (13) from the outside using the 2 mm hex key (20). Hold the
nut (18) in place from the inside using the jaw spanner (19).
Screw the enclosure onto the right and left sides using the countersunk screws (13).
15
16
Cleaning
• Always unplug the 3D printer from the power supply before cleaning it.
• Never use aggressive detergents, rubbing alcohol or other chemical solutions, as these could
damage the casing or cause the printer to malfunction.
• Use a dry, soft, and lint-free cloth to clean the product.
Disposal
Always dispose of the product in accordance with the relevant statutory regulations.
You thus fulfil your statutory obligations and contribute to the protection of the
environment.
Technical data
Dimensions (W x H x D) ............... 350 x 450 x 295 mm
Weight .......................................... 2.1 kg
