Step 15.
LOCK STOP PIN R-16
A. Inspect lock stop pin for damage and distortion.
B. The lock stop Pin is used on “Lock Open” clamps. The lock stop pin is
attached to the clamp body with a small link chain.
WARNING: Replace lock stop pins that are damaged or distorted.
Step 16.
ASSEMBLY
After reassembly, check operation of clamp. All parts should move freely
without binding. Refer to exploded view for proper location of component
parts.
WARNING: All retaining pins and fasteners must be in place.
GENERAL
RENFROE products may be returned to the factory for inspection and repair
in accordance with an established fee schedule.
Use only RENFROE replacement parts to insure maximum efficiency and
safety factor originally built into the product. Refer to RENFROE catalog for
instruction on ordering replacement parts.
WARNING: Do not weld, grind of modify the clamp body or component
parts in any manner. In the event the stenciling is worn and not legible
or the tag containing the model, capacity or other pertinent information
is missing—do not use clamp until it has been properly labeled.
