Renfert SIMPLEX 3D-Filament-Drucker, Setup

Page: 31 / 166

en
5.2 Setting the temperature unit
A video on this topic is provided under the following link
www.renfert.com/simplex-3-en and via the QR code shown.
⇒ Select the SETTINGS menu. �
⇒
Use the right arrow to go to page 2 (as shown here in the image).
⇒
Press the button with the temperature icon �
⇒ The unit can be changed by pressing the arrow buttons / at the top�
The factory setting is °Celsius.
⇒ Press the lower left arrow until you are back in the main menu�
5.3 Wi-Fi connection
A video on this topic is provided under the following link
www.renfert.com/simplex-8-en and via the QR code shown.
The Wi-Fi module is only available in EU member states and in the USA.
The button with the Wi-Fi icon can only be operated if the Wi-Fi module
is available.
The Wi-Fi module may only be used as an information tool for monitoring
printing. Print jobs cannot be started, paused, or stopped using the Wi-Fi
module.
⇒ Select the SETTINGS menu. �
⇒ Use the right arrow to go to page 4 (as shown here in the image).
⇒
Press the button with the Wi-Fi icon �
⇒
Press the button with the search icon to search for a Wi-Fi network.
♦ A list of Wi-Fi networks is shown
⇒
Use the up/down arrows / and select the required Wi-Fi network using
the checkmark �
⇒ Enter the password of the selected Wi-Fi network.
⇒ Confirm the password using the checkmark �
A connection was successfully established to the selected Wi-Fi network:
♦ The name of the connected Wi-Fi network is shown
♦ The IP address (LAN IP) allocated for the SIMPLEX 3D filament printer is
shown�
A connection could not be established to the selected Wi-Fi network:
♦ An error message is shown:
"No connection to host <Name of the WiFi network>"
⇒
Press the lower left arrow until you are back in the main menu�
Fig. 12
Fig. 13
Fig. 14
Fig. 15
- 11 -