RL78/I1A
Chapter 7 How to Use WriteEZ5 Flash Programming Software
Chapter 7 How to Use WriteEZ5 Flash Programming
Software
This chapter explains the basic operations of the WriteEZ5 GUI for programming
the
RL78/I1A DC/DC LED Control Evaluation Board
. This chapter covers how to
start the system, execute the EPV command (Erase, Program, Verify), and
program the target RL78/I1A device.
The conditions of the series of operations described in this chapter are as
follows:
Board:
RL78/I1A DC/DC LED Control Evaluation Board
CPU: RL78/I1A
Target Device:
R5F107DE
Voltage level:
5 V
Hardware
Configuration of
RL78/I1A DC/DC
LED Control
Evaluation Board
Parameter file:
R5F107DE.pr5
Clock setting:
Internal-OSC
Port: COMxx
(115200bps)
Software
Configuration of
WriteEZ5 GUI
Operation mode:
Chip
Write HEX file:
*.hex
Option Setting:
Blank check before Erase
Running the Software CD installation supplied with this product will automatically
deploy the correct software.
<1> Installing the
WriteEZ5 GUI
Running the Software CD installation supplied with this product will automatically
deploy the correct software.
<2> Installing the
driver
Running the Software CD installation supplied with this product will automatically
deploy the correct software.
<3> Installing the
parameter files
Set the
RL78/I1A DC/DC LED Control Evaluation Board
by configuring switch
SW2 as following:
<4> Setting and
connecting
Bits
Configuration
1 OFF
2 OFF
3 ON
4 OFF
5 ON
6 OFF
7 ON
8 OFF
SW2, Configuration for Flash Programming Mode
Table 11:
R01UH0363EJ0100 Rev. 1.00
15
March 23, 2012
