RL78/G23
ELCL Multiple Parameter Monitoring Function
R01AN5615EJ0200 Rev.2.00
Page 24 of 42
Mar.24.22
5.2 r01an5615_elcl_parameter.scfg
This is the Smart Configurator configuration file used in the sample code. It contains all the features
configured in the Smart Configurator. The sample code settings are as follows.
Table 5-1 Parameters of Smart Configurator (1/2)
Tag name
Component
Contents
Clocks
-
Operation mod: High-speed main mode 2.4 (V)~5.5 (V)
EV
DD
setting: 1.8V
≦
EV
DD0
＜
5.5V
High-speed on-chip oscillator: 32MHz
f
IHP
: 32MHz
f
CLK
: 16MHz (High-speed on-chip oscillator)
f
SXP
: 32.768kHz (Low-speed on-chip oscillator)
System
-
On-chip debug operation setting: COM port
Note
Pseudo-RRM/DMM function setting: Used
Start/Stop function setting: Unused
Trace function setting: Used
Security ID setting: Use security ID
Security ID
：
0x00000000000000000000
Security ID authentication failure setting: Do not erase flash
memory data
Components
r_bsp
Start up select : Enable (use BSP startup)
Control of invalid memory access detection : Disable
RAM guard space (GRAM0-1) : Disabled
Guard of control registers of port function (GPORT) : Disabled
Guard of registers of interrupt function (GINT) : Disabled
Guard of control registers of clock control function, voltage detector,
and RAM parity error detection function (GCSC) : Disabled
Data flash access control (DFLEN) : Disables
Initialization of peripheral functions by Code Generator/Smart
Configurator : Enable
API functions disable : Enable
Parameter check enable : Enable
Setting for starting the high-speed on-chip oscillator at the times of
release from STOP mode and of transitions to SNOOZE mode :
High-speed
Enable user warm start callback (PRE) : Unused
Enable user warm start callback (POST) : Unused
Watchdog Timer refresh enable : Unused
Config_LVD0
Operation mode setting: Reset mode
Voltage detection setting: Reset generation level (V
LVD0
): 1.86 (V)
Config_INTC
INTP0 setting: use
Valid edge: Falling edge
Priority: Level 3
Note. When using IAR, use by the following settings.
On-chip debug operation setting: Use emulator
Emulator setting: E2 Emulator Lite
