M30870T2-CPE User’s Manual
2. Setup
REJ10J0766-0400 Rev.4.00 February 16, 2006
Figure 2.9 Target status LEDs display when the emulator starts up normally (when user system connected)
IMPORTANT
Note on the Target Status CLOCK LED:
If the LED is not turned on, check the following.
(1) After powering on the emulator (before starting up the emulator debugger):
Make sure that the oscillator circuit board is properly installed in the emulator and it is oscillating normally.
(2) After the emulator debugger is started up (after the Init dialog box settings are completed):
Make sure that the oscillator selected in the Init dialog box is oscillating normally.
POWER
RESET
CLOCK
RUN
LED 3
LED 5
LED 4
LED 6
: ON
: OFF
When the user system connected:
When the POWER LED does not light, shut off
the system and check the setting of the
jumper switches, and if the power is properly
supplied to the user system.
Page 27 of 102
Summary of Contents for M30870T2-CPE
Page 102: ...M30870T2 CPE User s Manual ...
