WIRING
Air bags and seat belt pretensioners
88
After deactivating the air bag function using the
fault finding tool and removing the passenger air
bag module :
•
cut the passenger air bag wiring 60 mm from
the instrument panel wiring tape,
•
unsheath the passenger air bag supply wiring
by 30 mm,
•
strip the wiring provided in the kit and the
passenger air bag wiring by approximately 10
mm
,
•
thread 2 cm of heat shrink sleeving (provided
in the kit) on each of the vehicle’s wiring lines,
•
solder the vehicle’s wiring to the wiring in the
kit (B),
•
position the heat shrink sleeving over the sol-
dered joins and heat it,
15668R
•
refit and secure the passenger air bag module,
•
connect the new connector to the passenger
air bag module,
•
carry out a check using the fault finding tool.
Unlock the computer if everything is correct,
otherwise see the "Fault Finding " section.
SEAT BELT PRETENSIONERS
Description
They are mounted to the side of the front seats.
96438S
A pretensioner comprises :
- a special belt buckle (A),
- a pyrotechnic gas generator with its ignition
module (B).
DI8801R
88-16
