REMKO RVS 130 DC, Operating And Installation Instructions

Page: 4 / 44

Safety notes
Disposal of packaging
All products are packed for
transport in environmentally
friendly materials. Make a valuable
contribution to reducing waste
and sustaining raw materials.
Only dispose of packaging
at approved collection points.
Disposing of the units
and their components
Only recyclable materials are used
in the manufacture of the units
and components.
Help protect the environment
by ensuring that the units
or components (for example
batteries) are not disposed
of in household waste, but
only in accordance with
local regulations and in an
environmentally safe manner,
e.g. using authorised disposal and
recycling specialists or council
collection points.
Environmental
protection and
recycling
Carefully read the operating
manual before placing the unit
in service for the first time. It
contains useful tips and notes as
well as hazard warnings to prevent
injury to persons or material
damage . Failure to follow
the directions in this manual can
endanger persons, the environment
and the equipment itself and will
void any claims for liability.
■
Keep this manual and
the refrigerant data sheet near
the unit.
■
Only qualified personnel may
set up and install the units and
components.
■
The set-up, connection, and
operation of the unit and its
components must take place
in accordance with the operating
conditions stipulated in this
manual and comply with all
applicable local regulations.
■
Stationary units must be
permanently installed for
operation.
■
Modification of the units
and components supplied by
REMKO is not permitted and
can cause malfunctions.
■
Units and components may
not be operated in areas where
there is an increased risk of
damage. Observe the minimum
clearances.
■
The electrical power
supply is to be adapted to
the requirements of the units.
■
The operational safety of
the units and components
is only assured if they are
fully assembled and used as
intended. Safety devices may
not be modified or bypassed.
■
Do not operate units or
components if there are obvious
defects or signs of damage.
■
All housing parts and unit
openings, e.g. air inlets and
outlets, must be free from
foreign objects, liquids, or gases.
■
The units and components must
be kept at an adequate distance
from flammable, explosive,
combustible, abrasive and dirty
areas or atmospheres.
■
Contact with some parts of
the unit or components can
result in burns or other injuries.
■
Installation, repair and
maintenance work may only
be carried out by authorised
specialists. Visual inspections
and cleaning can be performed
by the operator as long as
the unit is disconnected from
the power.
■
Take appropriate precautions
when performing installation,
repair or maintenance work
or cleaning the unit to make
sure the unit does not pose
a danger to persons.
■
The units and components
should not be exposed to any
mechanical load or extreme
levels of humidity.
Guarantee
In order to make warranty claims,
it is essential that the ordering
party or their representative
complete and return the "certificate
of warranty" and “commissioning
report” to REMKO GmbH &
Co. KG at the time when the
equipment was purchased and
commissioned. The warranty
conditions are listed in the "General
terms and conditions".
Furthermore, only the parties
to a contract can conclude
special agreements beyond these
conditions. In this case, contact
your contractual partner in the first
instance.
REMKO series RVS
4