Switching the unit on
The unit is switched on by pressing the
key for 1 second.
A further 1 second press of the
key in the start screen will switch the unit back off again. After one minute
without being used, the display darkens.
Setting the operating mode
To set the operating mode, press the
key on the start screen for 1 second. The mode can thus be set to either
cooling
or heating
.
Setting the setpoint (return temperature)
To set the setpoint for the return temperature, briefly press the
or
key in the start screen. The display
flashes. Now the setpoint can be changed in steps of 0.5 with the same keys. Once the desired temperature is set,
confirm the input with the
key. The value set will be saved and you are returned to the start screen.
If there is no activity for 20 seconds during the set-up process, the system automatically returns to the start screen
without changing any of the settings.
In order to cancel the adjustment process, press the
key to return to the start screen without changing
any of the values.
Before setting the operating mode, this must be implemented by installing/removing a wire jumper
on the corresponding terminals (see chapter
Electrical connection
).
REMKO series RVS
10
Summary of Contents for RVS 130 DC
Page 2: ......
Page 41: ...Dimensions Unit dimensions RVS 50 DC RVS 80 DC RVS 130 DC RVS 180 DC 41 ...
Page 43: ...43 ...
