Fan MODE
Press the MODE key once
or repeatedly to switch
to recirculation mode.
In this mode, the unit is used
as an air circulation unit. The room
is neither heated nor cooled.
MODE
CIRCULATION MODE
This mode allows the heat
trapped under the ceiling to be
circulated to the lower regions
of the room in winter.
TIP
Heat MODE
SWING Key
The SWING key is used to provide continual and automatic vertical
adjustment of the fins. When switched on, the cooled air inside
the room is distributed better. If the SWING key is pressed during
the swing motion, the fins stop in their current position. Pressing
the key again resumes the swing motion.
SWING
SWING
Press the MODE key once or repeatedly to switch to heating mode.
Use this mode to heat the room air to the desired target temperature.
The prerequisite for this is that sufficient heat is present in the cold water
system.
Press the TEMP / key to set the desired room temperature in 1 °C
steps. If the room temperature is below the set target temperature,
the three-way valve provided by the customer opens.
If there is sufficient heating medium available, the indoor unit starts
to warm up the air in the room. If the actual temperature rises approx. 1 °C
above the set room temperature, the controller switches the valve off.
Heating mode:
We recommend setting
the target temperature
to max. 28°C. Maximum
fan speed and the lowest fin
setting should also be used.
TIP
Heating mode:
The fan will only start
when the fin temperature
reaches 38°C.
NOTE
MODE
HEATING MODE
SWING
SWING
SWING
SWING
Cooling mode:
We recommend setting
the target temperature
to max. 6 °C below
the outdoor temperature.
The automatic fan speed
and swing functions should
also be used.
NOTE
REMKO KWD EC series
12
