Carefully read the operating
manual before placing the unit
in service for the first time.
It contains useful tips and notes,
as well as hazard warnings
to prevent injury or material
damage . Failure to follow
the directions in this manual can
endanger persons, the environment
and the equipment itself and will
void any claims for liability.
■
Keep this manual close to the units.
■
The units and components
should not be exposed to any
mechanical load, and extreme
levels of humidity or sunlight.
■
Only qualified personnel may
set up and install the units
and components.
■
The set-up, connection, and
operation of the unit and its
components must take place
in accordance with the
operating conditions stipulated
in this manual and comply with
all applicable local regulations.
■
Mobile units must be set up
securely on suitable surfaces
and in an upright position.
Stationary units must be
permanently installed
for operation.
■
Modification of the units
and components supplied
by REMKO is not permitted
and can cause malfunctions.
■
Units and components may
not be operated in areas where
there is an increased risk
of damage. Observe
the minimum clearances.
■
The electrical power supply is
to be adapted to the requirements
of the units.
Safety notes
The units are shipped in sturdy
transport packaging. Immediately
check the units on delivery
and make a note of any damage
or missing parts on the delivery
note. Inform the forwarding agent
and contractual partner.
Claims under guarantee made
at a later date will not be accepted.
Transport
and packaging
Environmental
protection
and recycling
Disposing of packaging
All products are packed
for transport in environmentally
friendly materials. Make a valuable
contribution to reducing waste
and sustaining raw materials. Only
dispose of packaging at approved
collection points.
Disposing of the units
and their components
Only recyclable materials are
used to manufacture the units
and components.
Help protect the environment
by ensuring that the units
or components (for example
batteries) are not disposed
of in household waste, but only
in accordance with local regulations
and in an environmentally safe
manner, e.g. using authorised
disposal and recycling specialists
or council collection points.
■
The operational safety
of the units and components
is only assured if they are
fully assembled and used
as intended. Safety devices may
not be modified or bypassed.
■
Do not operate units
or components if there are
obvious defects or signs
of damage.
■
All housing parts and openings
in the unit, e.g. air inlets
and outlets, must be free
of foreign objects, liquids,
or gases.
■
The units and components must
be kept at an adequate distance
from flammable, explosive,
combustible, abrasive and dirty
areas or atmospheres.
■
Contact with some parts
of the unit or components can
result in burns or other injuries.
■
Installation, repair
and maintenance work may only
be carried out by authorised
specialists. Visual inspections
and cleaning can be performed
by the operator as long
as the unit is disconnected
from the power.
■
Take appropriate precautions
when performing installation,
repair or maintenance work
or cleaning the unit to make
sure the unit does not pose
a danger to persons.
■
The units and components
should not be exposed to any
mechanical load, extreme levels
of humidity or direct exposure
to sunlight.
REMKO KWD EC series
4
