Removing the Headguard
Before operating your shaver, remove
the headguard, which protects the
screen and cutter assembly. Simply
push up from the front or the back
until it pops off.
CAUTION:
Always keep the protective
headguard on the shaver head and
keep the trimmer in the OFF position
when the shaver is not in use.
Operating the Trimmer
Your shaver is equipped with a 3-
position trimmer.
Use the trimmer
button to extend or
retract the trimmer.
1.
Completely
retracted (down),
the trimmer is out of the way and
off, for when you want to use the
screens alone. Slide the trimmer
button down with your thumb to
get it into this position.
2.
In the middle position, the trimmer
works with the screens, cutting
the longer, hard-to-shave hairs so
the screens can get in extra close.
Slide the trimmer button into the
position level with the foils.
3.
Fully extended (up), the trimmer
can be used to trim your sideburns
and mustache. Slide the trimmer
into the top position, above the
foils.
7
How To Use
6
To Charge Your Shaver
Prior to using your shaver for the first
time, put it on charge for 24 hours.
■
Use only the charging adapter
supplied with the shaver.
■
Make sure your shaver is
turned off.
■
Connect the cord to the shaver,
then plug the charging adapter into
the electrical outlet. A charging
indicator light will come on.
■
Your shaver cannot be
overcharged, so you can leave it
plugged in and charging between
shaves.
■
To preserve the life of the batteries,
let them fully run out every six
months, then recharge them for a
full 24 hours.
■
The MS-700 is designed for
cordless operation only. Plugging in
the cord will not power the shaver.
To shave
Push the ON/OFF
button. Hold the
shaver so all screens
touch your face at
the same time. This
allows the shaver to
work the way it was designed for the
closest shave and minimum wear.
Avoid holding the shaver at an angle
so only one screen touches the skin
at a time. This will distort the screen
and could cause skin irritation.
Shave with short,
circular strokes. Use
your free hand to
stretch your skin.
This encourages
your whiskers to
stand out, making it easier for them
to enter the cutting chamber.
Never press hard. Pressing only flat-
tens your whiskers,
making it harder for
them to enter the
cutting chamber. It
will also wear out
the cutting surface
more quickly.
Adjusting to your new shaver
As with every shaver, your shave will
improve over time. Allow about three
weeks to develop an effective shav-
ing style and for your beard to adjust
to the new shaver. The adaptation
period may take a little longer if your
skin is sensitive, or if you alternate
between shaving methods.
To help smooth the transition to your
new shaver, Remington has applied
a special lubricant to the shaver’s
screens and cutters. The lubricant
looks like fine, white or gray powder,
and disappears with use.
Before you begin
■
Wait at least 15
minutes after getting
up before shaving, to
ensure your face is
free of puffiness that
may be present from
sleeping.
■
Make sure your face is
clean and dry before
starting.
■
Always use a clean,
dry shaver.
Usage Tips
6
12
9
3
S M T W
32389_ms-700_IB.indd 6-7
11/1/06 10:40:57 AM
