NEVER LEAVE HEATER UNATTENDED WHILE BURNING,
CONNECTED TO A POWER SOURCE, OR WHILE
CONNECTED TO A FUEL SOURCE
© 2015, Pinnacle Products International, Inc.
Convection Heater User's Manual
Lighting Instructions:
1.
STOP! Read all of the safety information
provided with this heater.
2.
Turn valve on propane cylinder
COUNTERCLOCKWISE until fully open.
3.
Wait five (5) minutes for any gas to clear. Smell
for gas. If none is evident, proceed to the next
step.
4.
Push in the valve knob and turn to "PILOT".
NOTE:
If this is first time use for heater or LP
cylinder has been replaced, hold the valve knob
for approximately 30 seconds to allow bleeding of
air from system then turn valve knob to PILOT.
5. While depressing the valve knob, press
red piezo ignition button to ignite. It may be
necessary to press the igniter button several
times to ignite the center burner panel.
6.
Continue to hold valve knob down for 30
seconds after the panel has lit. This will heat
the thermocouple. After 30 seconds, release
the valve knob.
7.
If heater fails to light, or does not stay lit, repeat
steps 2 through 6.
8.
When the center burner panel stays lit, turn the
valve knob to the desired setting.
Shut Down Instructions
1.
Turn valve knob to the
OFF
position.
2.
Turn the knob at the LP cylinder
CLOCKWISE
to the OFF position.
3.
Disconnect regulator hose assembly from the
LP cylinder.
Test Firing Heater
It is always a good idea to test fire your heater
in a safe and controlled environment, in an area
with adequate ventilation, and away from any
combustibles to be sure that all functions of the
heater and gas supply system are operating
properly.
Leak test all gas connections with a 50/50 solution
of dish soap and water. DO NOT use a flame to
test for leaks!
Moving and Positioning the Heater
There is a brake in each of the front wheels of your
heater that helps keep it in place when in use. To
engage the brakes, push the lever down on each
wheel. To move the heater, release the brakes,
simply by flipping the levers on both brakes up.
Operation
EXTREMELY HOT during operation. Do Not touch any metal components while in
operation. Keep gasoline and any other flammable liquids away from the heater.
WARNING
8
