Remcor Cornelius VANGUARD 245, Installation & Service Manual, Page: 25 / 71

20
569000203
INSTALLING OPTIONAL CUP LID HOLDER (ITEM 7)
(see Figure 8 and applicable Figure 10 or 10)
The optional CUP LID HOLDER (item 7) is to be hung on front of the Unit hood as follows:
1. Hold Cup Lid Holder up in position on front of the Unit hood.
2. Pull bottom of the Cup Lid Holder out slightly from the hood and at the same time, insert two pegs on top of
the Cup Lid Holder into slots in the plastic grille on top of the hood.
3. Lower bottom of the Cup Lid Holder and allow it to rest on the hood. The Cup Lid Holder is now in place on
the Unit.
INSTALLING OPTIONAL STRAW HOLDER (ITEM 14)
(see Figure 8 and applicable Figure 9, 10 ,or 11)
The optional STRAW HOLDER (item 14) is to be installed on the Unit as follows:
1. Loosen two screws securing right side of the front access panel to the Unit.
2. Pull the front access panel out from the Unit just far enough to allow inserting the slotted portion of the
Straw Holder in between the front access panel and the Unit. The Straw Holder must be positioned on the
Unit as shown in Figure 8.
3. After properly positioning the Straw Holder on the Unit, tighten the two screws securing the front access
panel which secures the Straw Holder to the Unit.