8.2 Unit connection
Proceed as follows to establish the connection:
1.
Open the control box covers by removing the
fixing screws and lifting off the covers.
2.
Feed the voltage-free cable through the
glands into the switch cabinet. Depending on
the selection of the cable cross section, a
suitable cable gland must be provided by the
customer.
3.
Then connect the cable in accordance with
the connection diagram.
4.
Ensure a correct rotating field.
5.
Mount all removed parts.
External enabling contact Operation/Standby
In addition to being operated with the controller or
the cabled remote control, the unit can be switched
on and switched off (standby) via an external
potential-free contact.
This contact is closed when delivered.
This enable is used for example to realise standstill
times at night or for the activation / deactivation of
a building control system.
General alarm signal (standard equipment)
The connection of a potential-free general alarm
signal, for example, for signalling or for further pro-
cessing to a building control system is possible as
standard equipment. Use the respective connec-
tion diagram for this purpose and pay attention to
the maximum contact loads.
Cabled remote control (accessory)
The cabled remote control is used, for example, for
the querying, programming or operation of the unit
from a remote location. Use respective installation
instructions for this purpose.
1 2
3 6 6 7 7 9 10
2
1
1: General alarm signal
2: External enabling
1
- +
G
N
D
1: Modbus connection
51
Summary of Contents for KWE 1060 Eco
Page 61: ...V Valves for hydronic balancing 45 54 W Warranty 5 61...
Page 62: ...REMKO KWE Eco series 62...
Page 63: ......
