C L O N I N G
STANDARD INSTRUCTIONS
Any MASTER radio (an EPI 3101A with the desired radio frequencies
and settings) is capable of transferring its program to another EPI 31 01A
or SLAVE. The radio receiving the program also is referred to as the
CLONE. The LAA0700 Cloning Cable will be required in the following
procedure.
1 .
2 .
Make sure that the battery packs for
both radios are charged.
Attach the MASTER switch end of
the cloning cable to the side
connector of the MASTER radio.
(Note: one plug of the cloning cable
has a push button MASTER switch.
This plug must be attached to the
MASTER radio.)
3.
Power up the MASTER radio by
rotating the off/volume knob
clockwise past the detent.
5 .
6 .
7 .
IMPORTANT:
The MASTER and
CLONE radios must be set to the
same Channel Group before cloning
is started. Do NOT clone Channel
Group 01 to Group 02 or vice versa.
To put the MASTER radio in the
programming mode, press and hold
the MASTER switch. Then press
the
FCN
key until the display shows
PROG Ch 0.
Review the values in the program.
Any changes required must be made
at this time.
Connect the other plug of the cable
to the side connector of the radio to
be cloned.
Power up the CLONE and set it to
the proper Channel Group.
EPI 3101A User’s Manual
2 3
Summary of Contents for EPI 3101A
Page 1: ......
