PROGRAMMING
There are three different ways to program an EPI 3101A radio:
A.
It can be programmed and/or reviewed using its internal keyboard.
This section of the manual describes that procedure.
B.
Another radio (MASTER) with the desired information can transfer
its programmed settings to the radio (SLAVE) by using a cloning
cable, LAA0700. See “Cloning” on page 23.
C .
It can be programmed from a computer by using a special RS-232
interface cable. That procedure is not described in this manual.
See page 26 for more details.
P R O G R A M M I N G - K E Y B O A R D M E T H O D
Radios are shipped with a removable door covering the keyboard and
display. Before programming or reviewing, remove the door. First,
remove the battery pack if installed. Then, engaging the door just below
the speaker grill, slide the door downward. Reinstall the battery pack.
Make sure the battery pack is charged.
1.
Turn the radio on.
2.
Select the Channel Group to be
programmed or reviewed.
3.
Press and hold the
FCN
key. After
approximately three seconds, the LCD will
display - - -
Id.
4.
Release the
FCN
key. The radio is now in
the password entry mode.
5.
Enter the six-digit Password Code.
IMPORTANT:
VVithout the correct Password
Code, you cannot proceed with reviewing
or programming. The same Password
Code is used for both Channel Groups.
New radios shipped from the factory are
assigned the Password Code 000000.
While entering the Password Code, the
display will not change, but a beep will
sound for each key pressed. If the
Password Code is entered incorrectly, the
radio will reset to normal operation. Try
again, starting at step 3.
EPI 3101A User’s Manual
9
Summary of Contents for EPI 3101A
Page 1: ......
