11
Complete disassembly is not recommended. Return the unit to an authorized dealer
for total disassembly and/or repair.
All maintenance or disassembly should take place on a flat, clean work surface covered
with towels or wipers so as to have a clean space for the disassembled parts.
Inspect each part during disassembly for wear, scratches, and cuts. Discard the worn or
damaged parts and replace with new factory authorized parts.
See parts drawings on pg16-20.
O-rings are sensitive to sharp edges. Inspect closely for cuts or damage. A small cut
will cause a leak. When assembling or disassembling O-rings, use hydraulic fluid as a
lubricant to help disassembly or installation.
When disposing of hydraulic parts or components observe all federal, state, and local guidelines.
IF YOU HAVE QUESTIONS REGARDING THE REPAIR AND MAINTENANCE
OF THIS TOOL CONTACT RELIABLE EQUIPMENT AT
800-966-3530
GENERAL MAINTENANCE
GENERAL MAINTENANCE
GENERAL MAINTENANCE
GENERAL MAINTENANCE
GENERAL MAINTENANCE
DAILY MAINTENANCE
The life, reliability, and safety of the tool is dependent on proper maintenance.
Clean and inspect all surfaces including head, latch mechanism, blade, ram, and body.
WARNING
blade, head may cut or pinch. Please use extreme caution.
Worn or damaged parts (i.e. chipped or cracked blade) may malfunction during operation,
causing more extensive damge to the tool and/or severe injury to the operator or bystander..
All parts must be replaced with new parts if signs of wear or damage are evident.
Keep Label Set clean and legible. Replace decals when necessary.
BEFORE USING THIS PRODUCT
READ THE SAFETY WARNINGS
and recommended practices described
in the manual. Failure by the operator to
read and fully understand the warnings
will leave this person unqualified to use
and operate the tool.
Failure to observe all warnings and instructions could result
in property damage, severe personal injury, and/or death.
ELECTROCUTION
HAZARD
The user should be properly
trained in the correct procedures
required for work on or around
electrical lines.
REL-SM
WARNING
Hardened metals may fly when
severed. Take necessary precautions.
waer safety glasses do not cut live
conductors. Keep fingers away
from cutting blades and moving parts.
Secure latch before operating.
Failure to secure latch can result in
severe tool damage and personal injury.
