13
U S E A L L A P P R O P R I AT E A N D A P P L I C A B L E
PERSONAL SAFETY PROCEDURES AND EQUIPMENT
AS REQUIRED BY THE OPERATING COMPANY.
Inspect, set-up and connect the tool as described on the
previous pages.
WARNING:
DO NOT
connect or disconnect the tool,
hoses, or
fi
ttings while the tool is running, hot, or under
pressure.
Serious injury or burns could result.
Replace all parts that show signs of wear or damage.
A damaged or improperly assembled tool may injure operator
and/or nearby personnel.
Set up desired operation. (ie. crimp, cut, or spearing).
Review and understand all operation and safety guidelines
relating to the operation to be performed.
Ensure that valve is in the
RETRACT
position before
initiating hydraulic power souce.
Activate the
REL-10-I-SA
by moving valve handle to the
ADVANCE
position.
The tool operation will begin immediately.
NOTE:
Moving the valve handle to the
HOLD
(center)
position will stop the tool action allowing for confi rmation
and repositioning as needed.
When relief valve popping occurs desired pressure has been
achieved and operation should be complete.
Repeat as necessary.
NOTE:
Holding valve handle in the ADVANCE position
after relief valve has popped will cause unnecessary wear
on relief valve and pump assembly.
Move valve to
RETRACT
and allow tool cutting blades,
crimping jaws or ram to return fully.
V
alve should be in the
RETRACT
position when not in use.
REL-10-I-SA OPERATION
LOW PRESSURE PORTS
(TO POWER SUPPLY)
HIGH PRESSURE
SINGLE ACTING PORT
VALVE HANDLE
REL-10-I
INTENSIFIER
PVA-00L3
3-WAY VALVE
REL-10-I-SA
INTENSIFIER/VALVE
Move valve handle to desired
action ADV (advance) or
RET (retract)
return to HOLD upon com-
pletion of operation
PVA-00L3
3-WAY VALVE
NOTICE
If you have any questions regarding the information found in this manual please
contact the supervising autority, or RELIABLE EQUIPMENT before continuing.
Phone: 215-357-3500 Toll Free: 800-966-3530 Fax: 215-357-9193
