Relative workshop V3 M-Series, Owner'S Manual

Page: 19 / 84

V E C T O R O W N E R ’ S M A N U A L
Page • 19
10 . Verify that the brake setting measurements are correct. Tighten the overhand knot at the toggle once more. It is
generally not a good idea to cut off the excess steering line, as you may want to adjust the steering toggles after the
canopy has been jumped.
11 . Repeat the procedure for the other toggle.
12 . Inspect the installation. Ensure proper routing of the steering lines.
METHOD B—SPECTRA STEERING LINES
1 . Ensure the steering lines are correctly routed (i.e. they should not wrap around any suspension lines). This is
accomplished by starting at the tail of the canopy. Trace the upper steering lines down to the lower steering line.
Check that the right hand steering line passes through the right hand rear slider grommet and the left hand steering
line passes through the left hand rear slider grommet.
2 . Locate the mark on the steering line that
indicates the correct toggle location. Verify
correct location of this mark by referring to the
reserve canopy owner’s manual.
3 . Thread the steering line through the guide ring
that is located on the riser.
5 . Slide the line off the looped end of the toggle
and tie a loose overhand knot in the folded line.
The mark on the
steering line that
indicates the correct
toggle position
should be 1 ¼ inches
(3cm) from the side of
the toggle.
4 . Starting from the hook and loop fastener
(loop side), thread the end of the steering line
through the Vector 3 steering toggle grommet.
Wrap the steering line around the outside of
the toggle and then over the grommet. The
mark on the steering line that indicates the
correct toggle position should be 1 ¼ inches
(3cm) from the side of the toggle.
n
ote
6 . Now slide the line back over the toggle.
Adjust the knot until the mark is just outside
of the knot away from the toggle. The loop
should fit closely around the toggle. Tighten
the knot.
section 2 : toggles attached to spectra lines