Profusion:
1.
Arrange the profusion modules and switch block into your desired layout.
2.
Use joining plates and supplied screws to fasten the modules to each other. Use the supplied D ring
hangers to hang the light assembly. Hangers can be fastened to any available threaded hole on the
back of each profusion module.
3.
String together the modules and switch block with dc connection cords by plugging the male end of
the cord into the female port in the lamp and turning the locking collar clockwise until snug. An
example setup can be seen in figure 2 below. Make sure there is a rubber plug in the open dc
connector in the last light of the string.
4.
Plug the male end of the power supply into the female port on the right hand side of the switch
block.
5.
Plug in the AC power adapter into a 120 VAC outlet.
6.
Use the switch on the switch block to turn the lamp on and off. The blue ring on switch will be off
when UV lamp is illuminated, and lit when lamp in powered down.
Important Note: Ensure the last lamp in the string has the rubber plug inserted into the open dc connector port,
this will ensure no foreign matter will enter the lamp. The 60 Watt supply will power 1-3 modules and the 120
watt power supply will power 1-7 modules.
