Nomad & Nomad-GO:
1.
Plug the M18 battery charger into a 120 VAC outlet.
2.
Slide the M18 battery onto the charger port. The red indicator light will turn green when the battery
is fully charged.
3.
Slide the fully charged battery onto the battery receiver of the Nomad or Nomad-GO lamp.
4.
Use the switch at the rear of the light to turn the lamp on and off. The blue ring on switch will be off
when UV lamp is illuminated, and lit when lamp in powered down. If equipped with a white light
(GO version) the left hand switch will operate the white LED lamp. If both switches are depressed
both lamps will be lit at a reduced intensity.
Important Note: A battery protection circuit will disconnect the battery when voltage drops below a safe
threshold. The battery indicator must show one or more bars of battery capacity to operate. Since the ring light
surrounding the UV lamp switch stays illuminated when the lamp is off, the battery will be discharged if stored for
more than a few days without removing the battery from the receiver. Please keep this in mind when storing your
lamp.
