WAL-SM-MHFL-1000W
-50C
1000W Portable Metal Halide Flood Light w/ Remote Ballast
110,000 Lumens - 50' Cord
Instruction Manual
Thank you for your purchase of the Larson Electronics
WAL-SM-MHFL-1000W-50C portable metal halide flood light.
WARNING:
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
CRITICAL SAFETY INSTRUCTIONS:
•
INSTALLATION SHOULD ONLY BE CONDUCTED BY A QUALIFIED ELECTRICIAN IN ACCORDANCE WITH NEC AND ANY
RELEVANT LOCAL BUILDING CODES.
•
RISK OF FIRE OR ELECTRIC SHOCK. FIXTURE INSTALLATION REQUIRES KNOWLEDGE OF
FIXTURE'S
ELECTRICAL
SYSTEMS. IF NOT QUALIFIED, CONTACT A QUALIFIED ELECTRICIAN.
•
BE CERTAIN ELECTRICAL POWER IS OFF BEFORE AND DURING INSTALLATION AND MAINTENANCE.
•
MAKE SURE THE SUPPLY VOLTAGE IS THE SAME AS THE
FIXTURE'S
RATED VOLTAGE.
•
TO PREVENT WIRING DAMAGE OR ABRASION, DO NOT EXPOSE WIRING TO EDGES OF SHEET METAL OR SHARP
OBJECTS. SUITABLE FOR DAMP LOCATIONS.
The WAL-SM-MHFL-1000W-50C Portable Metal Halide Light Fixture from Larson Electronics produces 110,000 lumens of
light in a wide flood pattern, is wet area rated and ideal for illuminating work spaces in a portable manner. The 1000-watt
unit comes standard with a remote ballast mounted on the pedestal stand. Operators are provided access to a 50` cord
with a cord cap.
Mounting
This unit is mounted on a heavy-duty galvanized steel pedestal stand. The frame features two
swivel casters in the front and two stationary casters in the back made with anti-static stainless
steel hardware for seamless wheeling around the workplace.
Unit will be shipped with the light
head removed. To install, align holes on light head mounting bracket with holes on pedestal
mount, then secure using a bolt through the top with a nut on bottom.
Simply wheel the unit into
the desired location and position on a flat, stable surface. Use the locking casters to keep the unit
from rolling around, and unlock them again to reposition as needed.
Tilt the light head by
loosening the screws on both sides of the unit, then tighten again to hold in desired position.
Wiring
We strongly encourage a licensed electrician install this product
, in all locations, especially
in outdoor areas where weatherproofing may be required.
Warning:
Check product label for correct input voltage!
This unit is available in multiple voltages and multiple cord termination options. Choose the one
applicable to your unit below.
For flying leads:
Secure each pair of wires according to the diagram. Utilize a junction box or similar device and
take precautionary steps for weatherproofing all connections if installed in a location where water
may come in contact with the unit. Ensure the unit is properly grounded, connected to the correct
supply voltage as specified on the product label, and that wiring is done according to all local and
national electrical/building codes.
Larson Electronics, LLC
Phone: (877) 348-9680
Fax: (903) 498-3364
www.larsonelectronics.com
1
of
2
This unit comes pre-wired from factory with the selected cord cap. Simply mate the cord cap with a compatible receptacle
outputting the correct supply voltage as identified on the product label. Take precautionary steps for weatherproofing all
connections if installed in a location where water may come in contact with the unit. All outdoor installations and indoor
installations near a wet location require the use of a GFCI device for safety, according to the National Electrical Code®
(NEC). Ensure the unit is properly grounded.
Attach supply line wires to the appropriate light fixture wires as shown
in the applicable diagram
For pre-wired
units with
cord cap:
