26
2.
Apply control units 1 and 2 to pressure until both working units are fully tightened towards
the telescope frame
3.
Press “F1“ to change to “working” mode
.
4.
“Fold apart“ Button
press the button above firmly until the symbol below appears on the screen of the control
5.
When
the beep sounds, press and hold the “!” button until the alarm
goes out.
4.5.
Fold the Respiro R9 together
Before bringing the machine into transport position, the following points must be observed:
•
Wait for complete standstill of all moving parts.
•
Make sure that there are no persons in the swivelling range of the machine.
•
If necessary, refer all persons from the swivel range.
1.
Make sure both rotors are in the lowest position
2.
Bring working units into headland position (Press control units 1 and 2 until both working
units are fully tightened towards the telescope frame)
3.
Raise the lower links so that the pick-up cannot collide with the ground while folding
together. Here, the rear hydraulics of the tractor was not raised high enough
This caused the
collision of the pick-up with the ground.
Attention WRONG!
terminal appears and the two working
units have moved up by the unit-upper
link in the headland position. Wait two
more seconds, then you can release the
“Fold apart” button.
