26
Touch
Screen
User
'
s
Manual
Programming
WITH TOUCH TECHNOLOGY
WITH TOUCH TECHNOLOGY
a.
b.
e.
c.
d.
3. Sectors: Pivot Only
a. “Location”
To determine a sector of the field, enter the beginning and end points of the selected sector in
degrees.
In this example sector 2 has been selected to run. [Use the BACK and NEXT buttons to navigate
through the sectors. To delete one sector from the program select remove. This will delete only that
sector. To delete all sectors from a program, use the CLEAR button.]
b. “Sector” dropdown
Select a sector program to set up. The system can will hold up to 3 sector programs and each sector
program can hold up to 25 sectors. Only one sector program can be run at a time.
c. “Moving Forward/Reverse Depth”
Enter the depth in inches and functions from the popup menu that should run while moving in the
forward or reverse direction respectively in the selected sector. See the pie chart below to determine
which sector is being programmed. For instance, if the sector shown needs an auxiliary pump to
turn on then you would set the depth (if needed) and select AUX1 on for either moving forward or
moving reverse or both depending on the need.
d. “Outputs”
Use the Popup Menu to select what needs to happen in each
selected sector. (i.e. pump on, pump off, cycle or pulse etc.)
e. “Pie Chart Grapic”
As sectors are programmed they will be highlighted in red at the bottom of the screen.
Note: For Lateral Move strip pro
g
rammin
g
please see pa
g
e 52.
