
POWER SOURCES
REI
CPM-700
14
The Charge LED light indicates the status of the power/battery circuits.
a.
If batteries are installed and the AC Adapter is connected, the LED
should be on. If not, check the Battery Selector Switch position
inside the battery compartment, the AC outlet for power, proper
polarity of each cell, and cell-to-cell contact in the battery holder.
If these are correct, then there may be a bad cell in the pack or a
defective AC Adapter.
b.
The charge LED should not be lit when either Alkaline or no
batteries are installed.
NOTE: Rechargeable cells will sometimes develop an internal short when
left discharged for long periods or when run flat (fully discharged). It is
recommended the battery pack be charged overnight after being run flat
and once every three months when not in use. If your battery pack develops
a shorted cell the “Low Batt” message will be displayed after a brief period
(up to 15 min. with RF Probe). If this happens try an overnight charge to
correct; otherwise, replace the defective cell.